Installing a roller garage door is a big project, but it’s not too difficult if you have the right tools and instructions. In this article, we’ll take you through the whole process, from the beginning to the end. We’ll discuss everything from site preparation to the installation of high-quality garage doors. We’ll also show you how to adjust the door after it’s been installed so that it opens and closes smoothly. By following our simple instructions, you’ll be able to install your new roller garage door in no time
Pre-Installation Checks & Components
Some pre-installation checks will need to be done before you get started. First, check that the roller door is the right size for your garage. You want it to be a manageable size. Next, check that you have all the necessary components and tools. You’ll need brackets, a bottom seal, a top seal, a center support, a side seal, a roller door motor, and a remote control.
Guide Channel Preparation And Fixing
The next step is to prepare the guide channels and fix them in place. To do this, you will need to measure the door opening and cut the guide channels to size. Once you have done this, mark out the fixing holes and drill them into place. Then, using the screws provided, fix the guide channels to the door opening.
Box And Barrel Assembly
Installing a roller garage door is a bit more involved than other types of doors, but it’s not as complicated as it might seem. The first step is to assemble the box and barrel. You’ll need to put the brackets in place and then attach the springs. Once that’s done, you can move on to attaching the roller door to the tracks. Start by attaching the hinges to the door and then the door to the tracks.
Fixing Of Frame
The next thing you need to do is to fix the frame. This is the frame that will support the roller door. To do this, you need to use screws and nails. Make sure that you use the right size so that it can hold the weight of the door. Also, make sure you use a level when fixing the frame to be straight.
Installation Of the Curtain
Now that your tools and supplies are ready, it’s time to start the curtain installation.
First, you need to measure the opening of the doorframe so that you know what size door to purchase. Then, you’ll need to install the brackets holding the roller in place.
Once the brackets are installed, you can put the roller into place and attach it. Then, you’ll need to install the bottom seal, which will help keep out drafts and moisture.
Finally, you can install the springs, which will help counterbalance the door’s weight so that it opens and closes easily.
Fitting Control Unit
You’ll need to install the control unit for your new roller garage door opener. This is usually fitted on the wall near the door at a comfortable height. Most units come with a template that you can use to mark out the drilling holes. Once you’ve done that, use a power drill to make the holes. Then, use the screws that came with the unit to bolt it into place. It’s important to ensure the control unit is level, so use a spirit level to check before tightening the screws completely.
Installing Of Lid And Overrides
Installing the lid and overrides is a pretty easy task. The first thing you need to do is to take the lid and place it on the garage door. Make sure that it is placed in the correct position. Once you have done that, you need to take the override and place it on the garage door. Make sure that it is placed in the correct position as well.
Commissioning
The final stage is commissioning the door. This just means checking that the door is balanced and that the travel limits have been set correctly. You can do this by disconnecting the door from the power, releasing it, so it’s fully open, and then letting it go. It should stay in place without support. If it doesn’t, you’ll need to adjust the tension.
Installing a roller garage door is a great way to add security and value to your home. Follow the instructions in this blog post, and you’ll be able to do it yourself in no time.
